Creality Space PI mods 2/2

Hi.Unlike my previous two mods to install these you will have to disassemble the dryer, so do it only if you are ready for this. There are disassembly videos on YouTube, so I’m not going to describe the whole process. In short, you have to remove the rubber legs to access the first 4 screws, and the screen cover (use hot air, for example a hair dryer, to soften the glue) to access the rest.The first one is a simple cover for the fan. The heater inlet is almost twice as wide as the fan outlet. And because the heater makes some resistance to the airflow, some air from the fan gets bounced back from the heater and escapes through this gap. When installed between the heater and the fan, this simple part covers the gap and makes the airflow better.The second mod is a simple cover for the onboard temperature and humidity sensor. This sensor is intended to measure temp and humidity within the drying chamber, but in its original position it measures air near the main board in the outer housing