Creality Space Pi Spool Holder

all credit goes to @laxcity_2873019 Space Pi is great, but it has two major problems regarding spools: Spools are tipping when become light, especially in case the spool itself is cardboard. Noticeable rolling resistance of stock shafts makes it hard to print with flexible materials like TPE or TPU.This solution solves both problems.No extra hardware required. Print reuses original bearings and shaft.Single design for Space Pi and Space Pi Plus.Support for any spool center bore - central washer, that aligns the spool, can be replaced to fit your spool needs.Support for all spools widths (that were initially supported by the box).Easy spool changes.Parts listFollowing amounts required for assembly of single holder (Plus version requires two holders).2 stands.2 wedges.2 nuts.2 washers.1 screw.1 outer spacer (2 in case of non-Plus version).1 inner spacer (0 in case of non-Plus version).PrintingInternals of the chamber can heat up to 70 degrees therefore it is necessary to print everything