Creality Spool Holder

*No additional hardware required.

Seen a variety of spool holders available but here is my version.

Its a Side Spool Holder 90degree. (will create a negative 30 degree version if requested only issue is max print size is reduced slightly.)

Original T slot nut from spool holder need to mount spool holder arm to mount.
The mount then slots into the end of the extrusion using t slot bars.

Most spool holders are on top, which tends to the filament binding in the extruder.
Other designs from the bottom pull the filament upwards adding drag on the spool. People print bearing spool holders to help with this.
This mount allows the filament to be pulled downwards towards the extruder with out binding or the need for a filament feeder arm.

2 variants:

First is with Logo and Hollow top for material saving.
Second is with out logo. Solid. But also a tighter fit. Ensure the Screws on top are tight down. This mounth (with a bit of persuasion) will slide over the bolt using