Creality spoolholder V2

I would suggest printing it with at least 3 perimiters and about 35% infill, support needs to be used at overhangs starting at 50 degrees.
Print the files in the orientation as shown in the pictures.

You will need:
2x or 3x 608 ZZ bearing (regular skateboard bearings)
2x or 3x Axle
1x Spoolholder
1x Bayonet Fitting Ring
1x Shim

If the spool holder is too loose you can use the scaling tool in your slicer to scale up the 2mm shim in the Z axis a few percent, if its too tight you can scale it down and make it fit. its also possible to fit an O-ring, works just as fine.

In the near future I will design a clip so you can use 40mm wide spools when using the spoolholder with 3 bearings. I use spools where the inner diameter is smaller in the center, if this is the case for you, i would suggest printing the version with 2 bearings or the version with 3 and using only 2 bearings.

I'd love to see pictures if someone makes this spool holder!