Thingiverse
Creativity ELF BLTOUCH Mount Bracket
von SkyTowers
8
Downloads
3
Likes
0
Makes
BLTOUCH MOUNT FOR CREATIVITY ELF PRINTER, SETS Z OFFSET TO ABOUT -1.38 MM FROM BED. TO BE SAFE I WOULD SET IT A LITTLE HIGHER AND ADJUST AS NEEDED.
HOLD THE MOUNT FIRMLY AGAINST THE METAL MOUNT WHILE TIGHTENING THE BOLT SO THERE ARE NO GAPS BETWEEN THEM.
SEND A MESSAGE IF YOU NEED HELP.
HOLD THE MOUNT FIRMLY AGAINST THE METAL MOUNT WHILE TIGHTENING THE BOLT SO THERE ARE NO GAPS BETWEEN THEM.
SEND A MESSAGE IF YOU NEED HELP.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
