Creativity Elf Cable Management

Cable management for the VGA cable on the Creativity Elf. You will need 4 M3x8 screws for the VGA connector cover, 2 M4 screws and t nuts for the 2020 end mount, and a large heavy duty cable tie. I found them a a local Rural King. I used one that was 35" long. A 24" was a couple inches too short.

Just print all the pieces, mount the two ends, place your head at the opposite corner form the 2020 mount, and trim your cable tie so it fits in both mounts and still has a little arc to it. Put the cable clamps (6) on the VGA cable. Run the cable tie through the clamps and push it into the end mounts. Voila! no more dragging cable problems.

I used supports on the StrainReliefCableTie piece only.