Thingiverse
Creativity Elf Upgrade Parts
door TegidTathal
48
Downloads
27
Likes
0
Makes
Update 08/07/2020:
Added new idler brackets. They replace the brackets at the front of the printer and require two extra M4x12 bolts and 2 M4 T-Nuts each (so really 4 bolts, 4 T-Nuts). I used printed T-Nuts. I printed them in PETG - if you want to run in an enclosure, you probably need to print in a more temperature tolerant material, but PLA should work in most cases as well.
The spacing between the top and bottom is larger to fit higher quality pulleys so you might need some extra washers to properly space your idlers in it, or you can leave the top pulley floating.
These blocks both add space for better pulleys AND realign these pulleys in 1.5mm on each side making the distance match up with the X-Gantry pulley on that side. However, I paired this with a smaller 16T pulley on the Steppers and a larger smooth idler on the other side of the X-Gantry to keep those sides aligned properly.
Updated 03/04/2020:
Added baffles for the hot end (these are close copies of the ori
Added new idler brackets. They replace the brackets at the front of the printer and require two extra M4x12 bolts and 2 M4 T-Nuts each (so really 4 bolts, 4 T-Nuts). I used printed T-Nuts. I printed them in PETG - if you want to run in an enclosure, you probably need to print in a more temperature tolerant material, but PLA should work in most cases as well.
The spacing between the top and bottom is larger to fit higher quality pulleys so you might need some extra washers to properly space your idlers in it, or you can leave the top pulley floating.
These blocks both add space for better pulleys AND realign these pulleys in 1.5mm on each side making the distance match up with the X-Gantry pulley on that side. However, I paired this with a smaller 16T pulley on the Steppers and a larger smooth idler on the other side of the X-Gantry to keep those sides aligned properly.
Updated 03/04/2020:
Added baffles for the hot end (these are close copies of the ori
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!