Thingiverse
Cribbage Board
door kgearhardt
23
Downloads
20
Likes
2
Makes
The tray has built in supports, and is intended to be printed "cavity down". I printed my on a textured sheet using PETG. The support will easily snap off to open the cavity, so that you can then insert the turn and straight blocks, and glue them in place.
You'll need two different colors for the turns and tracks. Print 21 of the 5-hole block in each color, 2 of the outside turn in each color, and 2 of the inside turn in each color.
I'll add some photos of the finished product later.
You'll need two different colors for the turns and tracks. Print 21 of the 5-hole block in each color, 2 of the outside turn in each color, and 2 of the inside turn in each color.
I'll add some photos of the finished product later.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
