Thingiverse
Crimp Tool, V 1&2
by JunkBox
21
Downloads
8
Likes
0
Makes
The crimping tool I have was designed for RG-58 coax. But I needed to crimp some RG-8. I didn't expect it to last for very many crimps, just a few and it did and using PLA.
Edit:
100% fill, Layer height 0.28mm, Wall Count 4.
Add picture of part installed. This was taken after use. A little distortion, but again it did better than I expected.
Edit:
100% fill, Layer height 0.28mm, Wall Count 4.
Add picture of part installed. This was taken after use. A little distortion, but again it did better than I expected.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
