Thingiverse
crkbd tenting feets
door jumar
5
Downloads
7
Likes
0
Makes
This is a design of 3D printable tenting feet for the [CRKBD Tented Case by RaihaX](https://www.thingiverse.com/thing:4619039).
The feet are designed for a 12 degree tenting angle and a plus or minus 5 degree tilt angle.
Feet bases are slanted to match the tilt/tent angle and lay flat on the desk surface.
*For -5 degree tilt:*
Print two of each file. The smaller one goes on the pinky side, the medium one close to the pro-micro connector and the longest ones near the thumb keys.
*For +5 degree tilt:*
Replace the medium size feet by long feet.
Simply press-fit the feet in the case holes, attach some anti-slip rubber on the bottom of them and you're good to go. No screw or any other hardware needed.
The feet are designed for a 12 degree tenting angle and a plus or minus 5 degree tilt angle.
Feet bases are slanted to match the tilt/tent angle and lay flat on the desk surface.
*For -5 degree tilt:*
Print two of each file. The smaller one goes on the pinky side, the medium one close to the pro-micro connector and the longest ones near the thumb keys.
*For +5 degree tilt:*
Replace the medium size feet by long feet.
Simply press-fit the feet in the case holes, attach some anti-slip rubber on the bottom of them and you're good to go. No screw or any other hardware needed.
jumar publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
