Crock Pot Handle

The handle broke on our crock pot lid. Throw it away and buy another crock pot? No! Designed in Inventor.

This lid was an oval one with two holes. The one hole had a silicone plug and the plastic engaged it so the handle would not spin. I omitted this and just put the plug in the hole. You will need an M6x16 Pan head screw and an M6 nut in Stainless steel to complete this.

PETG Filament, 4 wall, 15% infill.

I used a raft and generated support touching build plate. The supports took a bit to get all off, but it cleaned up nicely.

NOTE that the handle is concave on the bottom, not flat.

Handle fits perfectly!