Thingiverse
Crocs pin
von puneit
49
Downloads
57
Likes
0
Makes
The pin that holds the heel strap of my crocs fell off and was lost. I tried various designs available on Thingiverse but none work for me (too small or too fragile)
I removed the one available on my footwear and designed the replacement part in Fusion360.
Added chambers and fillets to avoid layer separation and give strength.
Since it is a small part, print slow - one pin should take about 5 to 8 minutes and uses 0.39 grams of filament.
I removed the one available on my footwear and designed the replacement part in Fusion360.
Added chambers and fillets to avoid layer separation and give strength.
Since it is a small part, print slow - one pin should take about 5 to 8 minutes and uses 0.39 grams of filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
