Thingiverse
cross-stitch iPhone SE case, outer shell
door perryrothjohnson
47
Downloads
67
Likes
0
Makes
An iPhone SE/5S/5 case that you can cross-stitch any design onto.
I remixed [this outer shell case](https://www.thingiverse.com/thing:4253149) by cutting a grid of square holes in it with OpenSCAD, then exporting a new STL file.
Some of the square holes closed up a bit more than I liked. So after the print finished, I went back and drilled all the holes out with a 1/16-inch bit, then deburred them with a 1/2-inch countersink. I also sanded down the rough surfaces on the inside of the case.
I remixed [this outer shell case](https://www.thingiverse.com/thing:4253149) by cutting a grid of square holes in it with OpenSCAD, then exporting a new STL file.
Some of the square holes closed up a bit more than I liked. So after the print finished, I went back and drilled all the holes out with a 1/16-inch bit, then deburred them with a 1/2-inch countersink. I also sanded down the rough surfaces on the inside of the case.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!