Thingiverse
Crossbones Mask
von meatswets
2.3k
Downloads
1.8k
Likes
9
Makes
Update 3/7/17:
Thanks to Dayne427 's awesome Redhood variant print (go check it out!) I've edited the back portion to include room for ears so that the helmet is easier to wear. I'm not sure what orientation Dayne427 printed the back portion but I included a pic of the Cura settings and orientation that I think would work best.
Note 3/5/17:
I kinda just realized that I really didn't explain how the mask and the back were supposed to attach. There are two vertical posts in the interior of the the back part. Those were originally meant as posts that one end of an elastic band could wrap around. The band is then supposed to feed out of the slots on the back of the helmet. The other end I originally planed to have Velcro that stuck to the mask. The interior of the mask on each side near the ear there should be a rectangular recess for the Velcro strip. This way the helmet should be able to slip onto the head pretty easily (theoretically).
Make sure to check out awesome makes by Jim
Thanks to Dayne427 's awesome Redhood variant print (go check it out!) I've edited the back portion to include room for ears so that the helmet is easier to wear. I'm not sure what orientation Dayne427 printed the back portion but I included a pic of the Cura settings and orientation that I think would work best.
Note 3/5/17:
I kinda just realized that I really didn't explain how the mask and the back were supposed to attach. There are two vertical posts in the interior of the the back part. Those were originally meant as posts that one end of an elastic band could wrap around. The band is then supposed to feed out of the slots on the back of the helmet. The other end I originally planed to have Velcro that stuck to the mask. The interior of the mask on each side near the ear there should be a rectangular recess for the Velcro strip. This way the helmet should be able to slip onto the head pretty easily (theoretically).
Make sure to check out awesome makes by Jim
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
