Thingiverse
Crossbow Disc Shooter
von newtrix
87
Downloads
81
Likes
0
Makes
Disc Shooter
Note the file has some supports already included to make printing easier. But supports must be added. Ideally Support Blocks would be used around the alignment pin holes, because its kind-of hard to dig them out. (But possible) The scraper works great to separate the supports after the print is done. This thing prints in two sections and is glued together when complete.
For a trigger, insert a thin nearly headless nail. You can use a soldering iron to melt the head into the plastic if the head is not much wider.
Item is adapted from Matthias Wandel Youtube video "Building a plastic cap shooter"
https://www.youtube.com/watch?v=DAGSFp_wFLo
Great News! Mattias has agreed to let me publish the files!
Note the file has some supports already included to make printing easier. But supports must be added. Ideally Support Blocks would be used around the alignment pin holes, because its kind-of hard to dig them out. (But possible) The scraper works great to separate the supports after the print is done. This thing prints in two sections and is glued together when complete.
For a trigger, insert a thin nearly headless nail. You can use a soldering iron to melt the head into the plastic if the head is not much wider.
Item is adapted from Matthias Wandel Youtube video "Building a plastic cap shooter"
https://www.youtube.com/watch?v=DAGSFp_wFLo
Great News! Mattias has agreed to let me publish the files!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
