Thingiverse
Crossbow for matches
door eskpetri
48
Downloads
41
Likes
0
Makes
Use ABS for bend properties. Crossbow bends more on left than it should. Use string about 57.25mm :) the gap between knots. Glue parts to gether. Small plastic part in arc is downwards. Maybe a printed string.
I got better results using 0.2mm layer height than with 0.1mm?!?
Use eye protection if using againts people. (not for your self...)
TODO: Make it not thump release but a mechnacilal release system as I wanted it first place. Make it glue less solution. Make it stronger that you could actually flame the macth using the matchbox as a medium to light the macth in front of the bow.
Use knife to enlarge the hole and on bottom of the arc if needed.
I got better results using 0.2mm layer height than with 0.1mm?!?
Use eye protection if using againts people. (not for your self...)
TODO: Make it not thump release but a mechnacilal release system as I wanted it first place. Make it glue less solution. Make it stronger that you could actually flame the macth using the matchbox as a medium to light the macth in front of the bow.
Use knife to enlarge the hole and on bottom of the arc if needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
