Thingiverse
Crossfire Race Antenna Mount
par piscaj
2
Téléchargements
2
Likes
0
Makes
TBS Crossfire Race Antenna mount.
The antenna mount should be printed with flexable filament, prefereably TPU. The protective cover is a bit longer than the pcb to accommodate the soldered side of the board that is heat shrunk. This way you can slide the whole bit right in. It may take some wiggling to get the antenna in, its a tight fit.
The antenna mount should be printed with flexable filament, prefereably TPU. The protective cover is a bit longer than the pcb to accommodate the soldered side of the board that is heat shrunk. This way you can slide the whole bit right in. It may take some wiggling to get the antenna in, its a tight fit.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
