Crossplane I4

Part List:
1X Crankcase
1X Upper Crankcase
1X Crankshaft
4X Piston Head
4X Wrist Pin
4X Connecting Rod
4X Rod cap
8X Connecting Rod Pin
3X Bearing Cap
1X Crank Lever
4X Crankcase Stud

Notes:
-The pins may take several prints to get right, since they are all slight press fits. Print all pins fully solid, they can break easily if you get them stuck in a part and try and finagle it out.

-Print the crankshaft standing up. Yes that'll be a lot of support, but it'll print more accurately

-Print the upper crankcase upside down (mating face of the head touching buildplate). This will also generate a lot of support material, but the bearing surfaces for the crankshaft need to be accurate

-Print the connecting rod with the upper hole vertical on the buildplate. Print the rod cap and bearing cap in the same fashion

-Print the piston head with the top of the cylinder against the build plate

-The connecting rod pins are slightly tapered. Make sure the larger diameter e