MakerWorld
Hueforge & Lithophane
Ver Modelo
Crow Ornate
44
Descargas
48
Likes
24
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 100x100mm in size. You can adjust the X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.1mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 2.5PLA BambuLab Basic Gray Transmission Distance: 3PLA BambuLab Basic White Transmission Distance: 6This print uses 4 unique filaments. Substitute to your own needs. Swap Instructions:Start with BlackAt layer #9 (0.8mm) swap to Blue GrayAt layer #16 (1.36mm) swap to GrayAt layer #20 (1.68mm) swap to White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!
Corp también publica en
338 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
