Thingiverse
Crown Headgear
von alreadytom
0
Downloads
0
Likes
0
Makes
This 3d print will fit a 4mm ring normally found at hobby lobby. We used the 100mm ring and
cut out a section until it would not vise on to our head. Then using a hot glue gun we are able to secure the ring from falling forward or backwards. some reaming is done to ensure there is a tight fit... I use a drill bit and just turned it by hand until i was able to have a snug fit with the
3d printed part and the cut section of the ring.
cut out a section until it would not vise on to our head. Then using a hot glue gun we are able to secure the ring from falling forward or backwards. some reaming is done to ensure there is a tight fit... I use a drill bit and just turned it by hand until i was able to have a snug fit with the
3d printed part and the cut section of the ring.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!