Slicer Discord
CRT Flyback Anode Wire Spacer – 3D-printbaar model van MakerWorld MakerWorld
Electronics

CRT Flyback Anode Wire Spacer

2 Downloads
4 Likes
2 Makes
Model downloaden
Designed this Flyback Anode Wire Standoff to install on vintage arcade CRT monitors. Should work with most vintage CRTs. Snaps on to flyback wires with ~5-6 mm diameter (tested on G07, K4900, K7000, and MS-9 monitor models) without crimping the flyback wire. Overall diameter of standoff is ~5 cm / 2 inches. Holes have been added to install a zip-tie to ensure the spacer doesn't fall off. STRONGLY suggest this is printed in PETG given the heat that can be given off by CRT monitors after extended use. Please leave a thumbs up if this model helped you out. :)
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PETG
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie