CRT Raspberry Pi Case

!!!!!!WORKING WITH CRTS IS DANGEROUS AND CAN RESULT IN SERIOUS INJURY IF YOU ARE NOT CAREFUL, ALWAYS DISCHARGE WITH A HIGH VOLT PROBE BEFORE WORKING WITH ONE!!!!!! Custom Case I made for a 5.5 inch CRT display and raspberry pi. I highly recommend using PETG or other more durable filaments compared to PLA. InstructionsThese are some rough instructions, so please leave a comment with any questions.You will need a soldering iron and solder, some electrical wires, electrical tape, m6, and m3 screws, as well as this type of switch which can easily be found on aliexpress or other electrical suppliers.Wire these to the power buttons for both your raspberry pi and CRT. The Design fits a 5.5 inch display (diagonally measured) very tight, so dont be afraid to use some force pushing it in (stop trying if it won't go in at all though, it is made from glass after all), then screw in the CRT's bracket.Next up you can screw in the Raspberry PI to its shelf, I had some trouble actually getting