Crusader Dice Shield

This is an Dice case made to resemble a Crusaders shield. With space to hold ample dice plus any mini figs or writing utensils needed. It gives enough carrying space for your equipment while only standing at 1.5 inches thick, 6 inches long and 4.25 wide. Model prints on 4 plates plus one plate for templates to cut out foam or felt for interior lining. Materials needed: 8- (3mm thick X 5mm wide) magnetsFelt of your choice for under side of top, I used 3mm thick felt.Your choice of foam for bottom inserts. I used 6mm thick soft foam.Super Glue Print with supports on for top lid. Top of lid with cross facing the print plate.Cut out and glue felt and foam if desired.Glue shield edge and then cross.Finish by gluing magnets in the holes. Careful not to push the magnets to far in as their is little additional space for glue. Thanks for checking out the model! Any feedback is welcome. More photos of the model can be found on my Etsy Shop: https://www.etsy.com/shop/CalciferCrafts