Thingiverse
Crutch holder
von agocs
4
Downloads
1
Likes
0
Makes
This is a bracket designed to fit a Drive crutch, approximately 14cm wide. I attached it to my nightstand so my crutches wouldn't fall over. I used 3M VHB tape, but I also included two 1/4" (approx 6-7mm) holes for screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
