Crutch stand

I broke my leg and need to use crutches for several months. While I sit or need to use my arms for brushing teeth etc., the crutches are difficult to lean on something. They always slip and fall unless a good corner is available. I designed these parts so that I can lean or hang my crutches on the table, behind the chair etc.

You should measure the diameter of your crutch pipe and modify the parameter "crutch_r" in the SCAD file, save as 'STL', and print the resulting STL. All other dimensions should scale automatically. You can also modify the length of the feet from the pipe by changing the "reach" parameter. This design is for a 22mm pipe and 60mm reach.

After print is complete, remove any support for the screw hole and make sure the screw passes through the hole easily. An M3-35 screw, washer and nut are needed, but the design can be changed for other screw sizes.

Before inserting the screw, pass the holder over the pipe of your crutch through the horseshoe opening. To '