Thingiverse
Crux35 XT30 mount
von usonic
6
Downloads
15
Likes
0
Makes
Scrap polarity markings on XT30 connector and make small notches there. Once XT30 is in mount, lock XT30 by putting two short filament pieces into holes.
Use spacers to prevent the mount sliding on standoffs. Spacers a bit too tight. Scale them or drill after printing.
I also rerouted and shortened wires.
Use spacers to prevent the mount sliding on standoffs. Spacers a bit too tight. Scale them or drill after printing.
I also rerouted and shortened wires.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
