CSL Brake Pedal

(Made for Fanatec CSL Pedals w/ Load Cell Brake Kit)

You could use this for any of the pedals, but I made it specifically to use for my brake pedal. I don't like how the original plastic pedal was curve so much. I can control the braking pressure much better with this in place. It also puts the brake pedal slightly higher than the accelerator, which I like.

I was afraid a stand-alone pedal printed out of PLA wouldn't hold up under repeated use, so I designed this to slide over the top of the original pedal. Turns out it works pretty well. Just remove the original brake pedal with the two screws in the back, then slide it into this from the side and screw it back down.

I printed this on it's side, along the front of the printer bed, with supports just for the slot. My printer was able to handle the rounded corners with no trouble

Basic printer settings:
layer height = 0.2 mm
perimeters = 3
top_solid_layers = 3
bottom_solid_layers = 3
infill = 10%
infill type = gyro