Geekvape S100 Stand, Cap, and Tank cover TPU

Just a stand to keep your Geekvape S100 from falling over on your desk, but also fits in a car cup holder.

I made mine from TPU.
If PLA makes too tight a fit, you can try to scale it up in your slicer by a few %

Also added a Tank Cap combo cover. also TPU for the Zeus tank
and a Tank cover and a Cap separate.

no supports needed
.2mm Layer Hight
I use Ziro TPU and keep the same slicer settings as for PLA and it prints very well.
no need to disable retraction or run slower then 40 mm