Cults3D
Gadget
Artemis Max 1 - 5,5 (22) caliber magazine, 17-slot magazine
by MiM_
0
Downloads
0
Likes
0
Makes
The assembly will require:
Two 5 mm diameter, 1 mm thick neodymium magnets
A 30x1,5 mm O-ring
Spring wire, 0.6 mm diameter, approximately 50 cm per spring.
Glue for gluing the centering ring and magnets into the prepared holes.
After printing, assemble the entire assembly so that the ring rotates freely in the receiver.
Screw on the spring, bend the ends (see photo).
Assemble, tension the spring with the ring, test the magazine's operation with bullets, and glue the ring to the
Two 5 mm diameter, 1 mm thick neodymium magnets
A 30x1,5 mm O-ring
Spring wire, 0.6 mm diameter, approximately 50 cm per spring.
Glue for gluing the centering ring and magnets into the prepared holes.
After printing, assemble the entire assembly so that the ring rotates freely in the receiver.
Screw on the spring, bend the ends (see photo).
Assemble, tension the spring with the ring, test the magazine's operation with bullets, and glue the ring to the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in