Cults3D
Various
Royal Enfield Himalayan/ grr 450 headlight and tacho riser
0
Downloads
0
Likes
0
Makes
You can raise the screen, clock and headlight by about an inch (28mm to be exact) by removing and relocating just one bolt.
This feature is actually to allow the bikes in India to run the front numberplate under the headlight.
You will also need this 28mm spacer and 2x longer (M5x50mm) cap screws.
It raises the screen and adds a little more space in the cockpit, putting the clocks closer to the line of sight - I don't have to look down as much.
No specific print settings required,
This feature is actually to allow the bikes in India to run the front numberplate under the headlight.
You will also need this 28mm spacer and 2x longer (M5x50mm) cap screws.
It raises the screen and adds a little more space in the cockpit, putting the clocks closer to the line of sight - I don't have to look down as much.
No specific print settings required,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in