Cults3D
Tool
20x40 (2040) Top Mount Spool Filament Holder
by dweith
0
Downloads
0
Likes
0
Makes
This design is to mount on a 20x40mm Aluminum extrusion end used on most small printer Z-Axis to permit filament pull on the extruder to be more horizontal than vertical. I found there to be too much slipping on my Tevo Michelangelo even with changing out the OEM plastic junk extruder with an all Aluminum MK8 with 40 tooth drive gear.
This almost zero (0) friction spool holder was part of the solution along with changing the 40 tooth drive gear to a 26 tooth on the MK8 Extruder.
CAUTION:
This almost zero (0) friction spool holder was part of the solution along with changing the 40 tooth drive gear to a 26 tooth on the MK8 Extruder.
CAUTION:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in