Cults3D
Various
Nissan Micra K11 interior center fan vent / grille
by lambonorbi
0
Downloads
0
Likes
0
Makes
I made a 3D printable interior center vent / grille model for the Nissan Micra K11 because a lot of them are broken.
You could print the whole set (left and right), it contains the little clips for the two sides too.
Looks almost the original exept it cant be adjust to sideways. You could still rotate up and down.
You could print with handle (like the factory one) or without it.
IMPORTANT!
For the clip print you need to use 0.2 nozzle because of the small size. The vens can be pri
You could print the whole set (left and right), it contains the little clips for the two sides too.
Looks almost the original exept it cant be adjust to sideways. You could still rotate up and down.
You could print with handle (like the factory one) or without it.
IMPORTANT!
For the clip print you need to use 0.2 nozzle because of the small size. The vens can be pri
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in