Cults3D
Game
Kid Gohan Bust 3D Print Model 201
0
Downloads
0
Likes
0
Makes
You can Use PLA or any other materials.
Layer height 0.2mm is enough.
15% infill is Good.
Supports Not necessary if you rotate it to the Bed.
Use any color you want it to Print.
Use it as Both Wall Hanging Or Table top.
Layer height 0.2mm is enough.
15% infill is Good.
Supports Not necessary if you rotate it to the Bed.
Use any color you want it to Print.
Use it as Both Wall Hanging Or Table top.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in