Slicer Discord
CTC Z-Endstop – 3D-Druckmodell von Thingiverse Thingiverse

CTC Z-Endstop

von KonPhil
26 Downloads
12 Likes
0 Makes
Zum Modell
Verstellbarer Z-Endstophalter, um schnell und einfach den Z-Endstop anzupassen, wenn man den Tisch sauber ausrichten will.

Benötigtes Material:
2x Muttern M3
2x Schrauben M3x16
2x Schrauben M3x6
4x Scheiben M3
1x Kabelbinder

4 neue Löcher wurden gebohrt.
2 für die Platte
2 für einen Kabelbinder, damit das Kabel nicht an die Y-Welle geraten kann.

Adjustable Z-Endstop mount for the CTC

Material:
2x screws M3x16
2x screws M3x6
2x Hexagonnut M3
4x washers M3

Just drilled 4 holes
2 for the mount
2 for a tie so the wire cant get in touch with the Y-Axis.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen