Thingiverse
Cubicle Hook
von AJsRaceway
24
Downloads
27
Likes
0
Makes
A hook for your cubicle wall. Designed for a top bar that is 2 1/8 in. (~54mm) wide and 1/2 in. (12.5 mm) high. Snap the back in first and lower the front into place.
This STL is for a hook with a width of 10 mm. Increase the z scaling (it is printed on its side) to make a hook that is thicker or thinner as needed. (The photo is a hook with a width of 15 mm, so it is scaled to 150% in the z axis.)
This STL is for a hook with a width of 10 mm. Increase the z scaling (it is printed on its side) to make a hook that is thicker or thinner as needed. (The photo is a hook with a width of 15 mm, so it is scaled to 150% in the z axis.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
