Cubicle Phone Mount

I had trouble with previous mounts printing, and holding my phone on the wall.
This is not exactly a re-mix, I made it completly new, but I did get the idea from the source I had it listed as a re-mix from.
As you can see from the first photo, the pins have been offset so that I can print them on my makerbot without having to print supports.
I have a Cisco phone, and this holds it close to the wall so that it does not rock side to side, and the pins are a tight fit to the phone holes on the back of the phone
My phone is a Cisco 7940.
Thanks for looking.