Thingiverse
Cuff Clip (REMIX)
16
Download
8
Likes
0
Makes
This is a remix of original PSVR Aim Shoulder Stock's Cuff Clip. All credit goes to the original designer FragRaider.
In the comments section, i noticed a lot of comments, saying that the clip can easily be snapped off, especially if printed in PLA. This happened to me, when i was removing some tree supports and i accidentally snapped off the clip.
I added a curved edge to the clip, making it thicker and harder to snap off. I also added a small block under the clip, to make it flush to the bed.
For this print, i set the infill to 30%, to ensure that the clip has a good solid infill. I also used "tree supports" in Cura. Layer height was set to 0.15.
In the comments section, i noticed a lot of comments, saying that the clip can easily be snapped off, especially if printed in PLA. This happened to me, when i was removing some tree supports and i accidentally snapped off the clip.
I added a curved edge to the clip, making it thicker and harder to snap off. I also added a small block under the clip, to make it flush to the bed.
For this print, i set the infill to 30%, to ensure that the clip has a good solid infill. I also used "tree supports" in Cura. Layer height was set to 0.15.
Syntaxcuemi3D pubblica anche su
1 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
