Thingiverse
Cup Tray
by TheTalent
1
Downloads
2
Likes
0
Makes
In the time of Covid-19, many members of The Church of Jesus Christ of Latter-day Saints were permitted to officiate the sacrament in their own homes. During other times, priesthood holders visit members who are unable to leave their homes to attend sacrament meeting due to limited mobility or other health reasons. This tray may assist for these purposes.
I designed this cup tray to hold up to 12 of the standard sacrament cups. It would fit neatly into a small sized Corelle brand bread and butter plate (about 170 mm diameter). Should also work in many other similar sized plates.
I only have a small build volume printer, so some corners are cropped for printing purposes. All sharp edges have been rounded.
Print upside down using white filament for best results. No supports necessary.
Disclaimer: This design is not endorsed by The Church of Jesus Christ of Latter-day Saints. Officiating the sacrament is always to be done under authorisation and guidance of local church leaders
I designed this cup tray to hold up to 12 of the standard sacrament cups. It would fit neatly into a small sized Corelle brand bread and butter plate (about 170 mm diameter). Should also work in many other similar sized plates.
I only have a small build volume printer, so some corners are cropped for printing purposes. All sharp edges have been rounded.
Print upside down using white filament for best results. No supports necessary.
Disclaimer: This design is not endorsed by The Church of Jesus Christ of Latter-day Saints. Officiating the sacrament is always to be done under authorisation and guidance of local church leaders
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
