Cupholder Insert

I'm going to be building a wood center console for an OBS Suburban. Last time I did this I made cupholder rings out of wood. I thought I'd get "fancy" this time and make some cupholder inserts. Details on that project.... front to back, I'm planning 4 cupholders (2 of the double prints), then a pocket, then a compartment with a lid, then two more cupholders at the back. I.e. water AND coffee for driver and passenger plus 2 more cupholders at the back for the second row. Underneath the cupholders and storage compartment will be a hidden amp and a small sealed (thought right now) enclosure for an 8" sub.

* I have not printed these. These were just something I drafted up as a starting point.

These are set up to be 91MM ID, which should exceed a 32oz Nalgene with a diameter of 3.5" (89MM). They are set to be about 2.5" deep. Fairly shallow, but if you read above, they will be above an amp and the total height of that part of the console will only be about 7".