Thingiverse
curtain tie
von andrewgm
3
Downloads
3
Likes
1
Makes
Three slightly different curtain ties. Each design prints 2 so that they are the support for each other.
There is a .5 mm gap between the 2 curtain ties. Scaling it down to work with smaller amounts of curtains worked for me at 75% but I haven't tried any smaller.
I was going to make them taller with more wraps but the test prints were hard to get on and off the curtains.
There is a .5 mm gap between the 2 curtain ties. Scaling it down to work with smaller amounts of curtains worked for me at 75% but I haven't tried any smaller.
I was going to make them taller with more wraps but the test prints were hard to get on and off the curtains.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
