Curveball Mech

Hello again after such a long time!
Another mech design I have been thinking about for a while but only got a chance to model once I got on winter break, using some more rounder shapes. In retrospect, very Zeonic in design. It comes with a new blaster design and a sword, both can be stored on the backpack.

I have also been tinkering with a new joint design that may be easier to put together and take apart, but I'm not sure how printable it is. I have 2 versions of the shoulder assembly available, one that uses a separate pin piece and one where the pin is part of one of the shoulder pieces. The separate piece would be good if the joint were to wear out as you can just replace the single pin, but it may be harder to print.

The hips also have a slightly modified design to make the thighs look more centered on the hips.

I've tested the designs in both ABS and PLA and it works, but the ball joints in the shoulders and the hinge joint in the hips wear out quite quickly in PLA and will ne