CUSTM Wallet - Lasts Forever

The CUSTM wallet has been tested and continuously improved over a period of two years. Features: Space for up to six standard-sized cards Space for banknotes, coins and other small items Sliding closure with magnets 98% 3D printable Minimal assembly time Prints without support Items you need: Two 6x2 mm Magnets (round) Three short filament parts Assembly Carefully hammer the magnets into the holes (place a non-magnetic object on top of the magnet to prevent it from sticking to the hammer) If the magnets do not stick, use a little glue Press the CardSlicer onto the corresponding pin on the CardSlot. Now place the CoinSlot on top of the CardSlot and insert a small piece of filament (1.75 mm) into the holes provided. I recommend ABS. You may need to tap it in gently. For this, it is advisable that the piece of filament be no longer than 2 cm. Now trim the filament so that it is flush. Now you can insert the cover’s pin into the hole in the CardSlicer. You can glue it in place, but it will