Custom Bench PSU Housing

A housing for a combination of a number of electronic modules to make a bench power supplies that takes in AC power.
1) DC2416 - AC to DC converter
2) D3806 - DC to DC converter
3) Digital Volt/Amp Meter with Shunt
4) Digital Thermometer / Another Volt/Amp meter?
5) Double rocker switch

Instruction:
You'll need to orientate the top piece either up side down or 20 degree to flatten on the face with irregular shapes. both require the minimum support.

*Note 1: the holes are cutout with exact measurements. to compensate the shrinkage of the material you gonna be printed out you'll need to scale it up to 102% -103%.

You'll need some M3 screws to mount the 2 electronic module and the shunt. the rest should snap fit into the holes. Stands off are not required.
The DC2416 & shunt should be screwed onto the base. D3806 screw to the Top from the bottom of the module. the 2 half should be able to snap fit together

*Note 2: Before you mount the D3806, you'll probably need