Thingiverse
custom case for KBD67 mk2 rev 3
von miccth12370
12
Downloads
17
Likes
0
Makes
Now tested and tried and the design slightly altered for better printability.
Materials needed to reproduce what I did:
8x Heat set M3 threaded inserts
8x M3 bolts (I used 20mm but they ended up being too short. Go with 30mm.)
2mm craft foam cut to strips the size of the gasket tabs
Kbd67 MK2 REV3 OR Any PCB that works with the TOFU65 case.
Cut the files in half so you don't have to when printing.
Designed to laser cut the plate from 1.5mm material. Case should be fully 3d-printable.
Layout raw data:
[{a:7},"","","","","","","","","","","","","",{w:2},"",""],
[{w:1.5},"","","","","","","","","","","","","",{w:1.5},"",""],
[{w:1.75},"","","","","","","","","","","","",{w:2.25},"",""],
[{w:2.25},"","","","","","","","","","","",{w:1.75},"","",""],
[{w:1.25},"",{w:1.25},"",{w:1.25},"",{w:6.25},"",{w:1.25},"",{w:1.25},"",{x:0.5},"","",""]
Materials needed to reproduce what I did:
8x Heat set M3 threaded inserts
8x M3 bolts (I used 20mm but they ended up being too short. Go with 30mm.)
2mm craft foam cut to strips the size of the gasket tabs
Kbd67 MK2 REV3 OR Any PCB that works with the TOFU65 case.
Cut the files in half so you don't have to when printing.
Designed to laser cut the plate from 1.5mm material. Case should be fully 3d-printable.
Layout raw data:
[{a:7},"","","","","","","","","","","","","",{w:2},"",""],
[{w:1.5},"","","","","","","","","","","","","",{w:1.5},"",""],
[{w:1.75},"","","","","","","","","","","","",{w:2.25},"",""],
[{w:2.25},"","","","","","","","","","","",{w:1.75},"","",""],
[{w:1.25},"",{w:1.25},"",{w:1.25},"",{w:6.25},"",{w:1.25},"",{w:1.25},"",{x:0.5},"","",""]
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!