Slicer Discord
Custom Clock Kit 011 – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Custom Clock Kit 011

45 Downloads
31 Likes
12 Makes
Zum Modell
This is my take on the Maker World Clock Components Kit-011 The second hand that is provided with the kit will need to be permanently modified for the use of this clock--bend the thin metal arms sticking out from the mounting pin several times, they will eventually break off cleanly, with ease. -small dab of glue in the 3D printed second hand then insert the mounting pin inside (shown in photos)-insert clock component kit and lock to the face with the provided hardware-slide each hand over the clock module in order (they fit nicely, don't press hard)-slide face into the outer ring, its sized just right to allow to you remove the face if needed-screws for base need to be cleaned by tightening and loosening them a few times (progressively making them tighter each time) before they go in smoothly This clock has a lot of potential for custom faces, I plan to do a couple for around the house and one that has wacky colors for my oldest son. I hope you enjoy this design and if you have an
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen