Slicer Discord
Custom Mechanical Keypad with Display (Remix) – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Custom Mechanical Keypad with Display (Remix)

5 Downloads
8 Likes
1 Makes
Zum Modell
This is a remix of the Custom Mechanical Keypad with Display by JayFi: https://www.thingiverse.com/thing:2749209I raised the back of the enclosure for better visibility when sitting on a desk and sunk the keys in for what I thought was a better look.The remix was done in Tinkercad so there are some blemishes and it can likely be improved on. In particular, the front feet for the base seem to be pretty hard to slide into the top portion.Once assembled I'd suggest adding adhesive rubber feet to the bottom to keep it from sliding around when trying to press buttons.One thing that JayFi doesn't mention in the original Thing is that this project works best with a 3.3v Arduino Pro Micro, 5v can be made to work but would require additional wiring to change the voltage.Keycaps are a remixed version (For a tighter fit) of the ones found on the Stream Deck/ Marco Keyboard by CDante found here: https://www.thingiverse.com/thing:4186055One final tip I will give is that the original Arduino Sketch
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen