MakerWorld
Jewelry
Model downloaden
Custom TPU Bracelet
908
Downloads
314
Likes
292
Makes
MembershipWant to sell prints of this model?Boost MePlease leave a boost if you like the modelTo make this custom bracelet I used TPU 95A.From the configuration of the slicer you can change the text to be engraved on the bracelet, I recommend a thickness of 0.6.Unfortunately the slicer does not support TPU, to overcome this problem I have set a pause at layer 14 that will allow you to replace the color of the filament with another one always in TPU.When you have finished printing, be very careful to remove the support in the area of the block and then glue the second printed piece with cyanoacrylic glue. I hope you enjoy the bracelet!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
