Customisable Cable/ Pipe Clip (Remixed)

I needed to be able to print several different heigh clips to mount a gas pipe to my wall, so I adapted the existing one from Rob Hague to allow for that. This lets you set the bore, width, length of the wings, and height of the internal hoop (measured from very bottom, to inside edge of the loop).Options to modify are:Bore - Thickness of the cable or pipe you are going to be mountingInternal Height - How far away from the mounting surface you want the loop to end (from bottom of the mounting wings to internal side of the loop at the top)Wall - How thick you want the actual clip to beWidth - How wide you'd like the clip to beWing Thickness - If you need the wings/ mounting arms thickerWing Arm - How long you need each wing/ mounting arm to beScrew Clear - How wide the screw hole should be i.e for a 6mm screw, this should be 6mmCSK Diam - Counter sinking diameter, how wide you want the counter sunk hole to end upCSK angle - what angle you want the countersunk hole to be at (to try a