Thingiverse
Customisable Case for Pinecil & Tips
by J4m4l
12
Downloads
14
Likes
0
Makes
A fully customisable case for a Pinecil, accommodating zero or more tips.
There are already lots of Pinecil cases on here but I was surprised to see none would hold the 5 tips (the short one that came with it plus a set of 4) which must be quite a common configuration.
I've uploaded ready-made STLs for a single tip and the five-tip config that I use but you can use the Customizer to generate STLs for a case to suit however many tips you own. Almost everything is configurable, but you shouldn't need to change anything other than `numberOfShortTips` and `numberOfLongTips`.
It takes a while to render in the Customizer because there's a surprising amount that goes into the model so be patient.
There are already lots of Pinecil cases on here but I was surprised to see none would hold the 5 tips (the short one that came with it plus a set of 4) which must be quite a common configuration.
I've uploaded ready-made STLs for a single tip and the five-tip config that I use but you can use the Customizer to generate STLs for a case to suit however many tips you own. Almost everything is configurable, but you shouldn't need to change anything other than `numberOfShortTips` and `numberOfLongTips`.
It takes a while to render in the Customizer because there's a surprising amount that goes into the model so be patient.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
