Customizable Action Figure Display Base

I have a number of Toy Biz Lord of the Rings action figures from 2005/2006 for which I found it difficult to find display bases that fit. So I decided to make my own and make it customizable.

The default base is designed for a 2" diameter, 2mm height with a 3 mm peg at 4mm high. This peg would be too large for most smaller 6" action figures. You would need to measure the hole in the figure's foot to customize properly. A 2mm diameter peg at 2mm height may be a good starting point for smaller figures.

This supports the following shapes: Round, Triangle, Square, Pentagon, Hexagon, Heptagon, Octagon, Decagon and Dodecagon

TIP: It's a good idea to print 2 or more at a time. This gives each layer time to cool when printing the peg. Printing a single base at a time can result in the peg warping when the next layer is printed.

NOTE: You may need to experiment with the positioning of the peg for some shapes more than others. The peg does not automatically adjust its posit